Industry Pack Carrier Cards AcPC8625A CompactPCI Carrier Cards for Industry Pack Modules Four Industry Pack mezzanine module slots ◆ Non-Intelligent carrier card ◆ CompactPCI bus interface ACPC8625 TRANS-C200 Description Key Features & Benefits The AcPC8625A is a non-intelligent slave ■ Four industry-standard IP module slots board that interfaces four IP modules to the ■ Board resides in memory space CompactPCI (cPCI) bus. All 200 I/O points are brought out the rear J4 and J5 connectors. ■ Supports 8 and 32MHz operation This convenience eliminates messy cables from ■ Supports IP module I/O, ID, INT, and MEM hanging out the front of the cage. In addition spaces to a more efficient cage wiring design, it is also much easier to insert and replace boards. And ■ 200 I/O points with rear access with Acromag’s 80mm transition module ■ High-density rear connectors (TRANS-C200), all 200 I/O points are easily ported out the back of the cage. ■ Compatible with all CompactPCI CPUs ■ Plug-and-play carrier configuration and interrupt support ■ Two interrupts per IP module ■ Front panel LEDs ■ Supervisory circuit for reset generation ■ Individually filtered and fused power to each IP ■ Ruggedized with ESD strip and EMC front panel ■ Easily integrate IPs with your software using RTOS VxWorks, Linux, or Win DLL for Windows® 2000/XP/Vista/7 32-bit sytems. ■ Clean system cabling. ■ Easy board replacement. ■ Simplified debugging with status LEDs. ■ ■ ■ ■ Tel 248-295-0310 Fax 248-624-9234 solutions@acromag.com www.acromag.com 30765 Wixom Rd, Wixom, MI 48393 USA Bulletin #8400-265c cPCI Backplane Industry Pack Carrier Cards AcPC8625A CompactPCI Carrier Cards for Industry Pack Modules ■ Power Requirements Performance Specifications Ordering Information Power +3.3V (±5%): 300mA maximum. ■ General Carrier Cards +5V (±5%): 30mA maximum. Acromag’s carrier boards provide full data access to AcPC8625A ±12V (±5%): 0mA (not used). the IP module’s I/O, ID, interrupt spaces, and memory. CompactPCI carrier. Holds four IP modules. Plus IP module load. With full access to the programmable registers, you AcPC8625AE MTBF can easily configure and control the operation of the IP Same as AcPC8625A plus extended temp. range. Contact factory modules from the CompactPCI bus. Accessories Up to two interrupt requests are supported for each IP ■ Environmental module. All board interrupts are mapped to PCI bus 5028-438 Operating temperature INTA# signal. Cable, SCSI-2 to SCSI-2, shielded. -25 to 85°C (AcPC8625) Individual passive filters on each IP power supply line 5028-378 or -40 to 85°C (AcPC8625E models). provide optimum filtering and noise isolation between Termination panel, SCSI-2 connector, Storage temperature the IP modules and the carrier board. 50 screw terminals. -25 to 85°C (AcPC8625) IP Compliance (ANSI/VITA 4) TRANS-C200 or -40 to 85°C (AcPC8625E models). Meets IP specs per ANSI/VITA 4-1995 (8MHz and Transition module Relative humidity 32MHz) and IP I/O mapping to PICMG 2.4 R1.0. See www.acromag.com for more information. 5 to 95% non-condensing. Electrical/mechanical interface Software Development Tools Supports single or double size IP modules. 32-bit IP modules are not supported. IPSW-API-VXW ® VxWorks software support package IP Module I/O space, ID space, INT space, and MEM space supported. IPSW-API-WIN32 32-bit Windows® DDL driver and demo software Interrupts Supports two interrupt requests per IP module and IPSW-API-WIN64 interrupt acknowledge cycles via access to IP INT 64-bit Windows® DDL driver and demo software space. IPSW-API-LINUX ™ Linux support (website download only) CompactPCI bus Compliance See www.acromag.com for more information. Meets PCI spec. V2.1 and PICMG 2.0, R2.1. Data transfer bus Slave with 32-bit, 16-bit, and 8-bit data transfer operation 32-bit read/write accesses are implemented as two 16-bit transfers to the IPs. Interrupts CompactPCI bus INTA# interrupt signal. Up to two requests sourced from each IP mapped to INTA#. Interrupt vectors come from IP modules via access to IP module INT space. Plug-and-Play The system maps the base address into the PCI bus 32-bit memory space. ■ ■ ■ ■ Tel 248-295-0310 Fax 248-624-9234 solutions@acromag.com www.acromag.com 30765 Wixom Rd, Wixom, MI 48393 USA All trademarks are property of their respective owners. Copyright © Acromag, Inc. 2011/2012. Data subject to change without notice. Printed in USA 1/2012.