Wzzard™ Intelligent Edge Node With SmartMesh IP and Bluetooth LE • Ultra low power 802.15.4e SmartMesh IP technology • Communicates with Spectre Network Gateway via highly scalable and reliable wireless mesh networks • Connect to industry standard analog or digital sensors • Wzzard app lets you read or configure the nodes using Android tablets and smart phones • Rugged, IP66-rated, fiber reinforced polyester PBT enclosure • MQTT and JSON IoT protocol to application platform • Class 1 DIV 2 approved for hazardous locations SPECIFICATIONS POWER (2) 3.6V 2400 mAH Lithium Thionyl Chloride AA Internal batteries PRODUCT FEATURES Multiyear based on 1 min sensor sampling and Battery Life reporting Optional External Input Voltage 3.3 VDC +/- 5% Wireless Connectivity Where You Need It The Wzzard™ intelligent wireless sensor platform creates a complete, quick MECHANICAL and easy connectivity stack between your sensors and your application, on your M12 Connector network or on the Internet. The platform uses Intelligent Edge Nodes, a wireless Physical Connection 1/2” (12.7 mm) Conduit, sensor interface cable 802.15.4e SmartMesh IP network to transmit sensor data to the Spectre Network included; 8 wire, 26 gage, 6 ft. (1.8 m) Gateway. The Spectre Network Gateway can connect to the Internet via wired Analog Input (0 - 5 VDC, 0 – 20 mA, 4 – 20 mA) connections or the cellular data networks and communicate with application Digital Input (0-48 VDC) platforms using the MQTT IoT protocol and JSON data formats. Digital Input Frequency 1-1K Hz (Accuracy + or – 1 Hz) The Wzzard Intelligent Edge Nodes nodes accommodate virtually any industry- Sensor Inputs Digital Input Counter standard external sensors. Connections can be made via conduit fitting, cable Integrated Accelerometer 3 Axis gland or an M12 connector. The Nodes provide a wide variety of sensor interface Integrated Temperature options, including general purpose analog inputs, digital input/output and Thermocouple J, K Type thermocouple. They can also contain internal sensors like an accelerometer, Digital Output (0-30 VDC) depending upon the model number. All 802.15.4e Wzzard Intelligent Edge Nodes contain an internal temperature sensor. RP-SMA, Omnidirectional, 3.8 dBi, 2.4 GHz Optional External Antenna Dimensions 7.64 inches (194 mm) Secure, Reliable and Highly Scalable Wireless Networking Magnetic mounting via internal magnet The Wzzard platform uses mesh networking and time-synchronized channel Pull force 4.7 lbs (2.13 kg) Mounting hopping to provide up to 99.999% connectivity, even in the most demanding RF (4) Mounting ears, M5 (#10) environments. New nodes may be added at any time, and the SmartMesh IP Enclosure IP66-rated, fiber reinforced polyester PBT network will dynamically self-configure as new nodes are added or removed. Weight 0.75 lbs (0.34 kg) This is a function of the mesh network itself, and does not need to be controlled TECHNOLOGY by the network gateway. Wireless 802.15.4e, SmartMesh IP Easy Configuration and Installation Protocols MQTT-SN, MQTT, JSON Configuration of the Wzzard sensor platform is easy via Android smart phones Bluetooth Bluetooth 4.0 Low Energy (LE) or tablets. Using the Wzzard app, your handheld devices can configure the LED Network Connectivity Wzzard Intelligent Edge Nodes over their Bluetooth LE connections. The Wzzard ENVIRONMENTAL Intelligent Edge Nodes can be configured with calibration and scaling information, Installation Indoor or outdoor eng. units, friendly names, geolocation and other descriptive information. Operating Temperature -40 to 80°C (-40 to 176°F) The platform simplifies physical installation as well. The Wzzard Intelligent Edge Storage Temperature -40 to 85°C Nodes can be attached to any surface using screws or their embedded magnetic Operating Humidity 0 to 95% Non-condensing bases. The IP66-rated, fiber reinforced polyester PBT housing makes the units WIRELESS SECURITY deployable in virtually any industrial or commercial environment. Device Authentication 128 bit AES-based encryption with multiple keys Intelligence at the Network Edge Message integrity check (MIC) The Wzzard wireless platform places intelligence at the network edge. The Synchronized key changeovers Wzzard Intelligent Edge Nodes can be configured to communicate data only when specified threshold or alert levels are exceeded. When reporting, they Customized key rotation can associate useful information like geolocation, device name and uptime. This eliminates unnecessary network traffic, eases the processing burden on upstream resources, and cuts the cost of cellular data plans when the Gateway is using the cellular data network. Thanks to low-power wireless technology and programmable time synchronization, the Intelligent Edge Nodes can operate for multiple years on battery power All product specifications are subject to change without notice. www.advantech-bb.com / Enabling an Intelligent Planet 955-22600 series_PCI Express Adapters_4915ds Wzzard™ Intelligent Edge Node With SmartMesh IP and Bluetooth LE SENSOR INTERFACE SPECIFICATIONS DIGITAL INPUTS Voltage range 0 – 48 VDC V 0.97 V Maximum IL V 1.8 V Minimum IH Pull up current 32uA Type Sourcing (PNP)/Sinking (NPN) Software selectable input Isolation None RATE/FREQUENCY INPUTS Does a 1 second measurement at each measurement/publish interval Frequency Digital Input Frequency 1-1K Hz (Accuracy + or – 1 Hz) Uses the falling edge or rising edge based on the Invert Enabled setting COUNTER INPUT Actively counts either the falling edge (Invert enabled) or rising edge (Invert disabled) Can use a multiplier to convert to a unit type or count Channels 2 selectable/shared with Digital inputs Rolls over at 999999.9 ANALOG INPUTS Input ranges 0 - 5 VDC, 0 – 20 mA, 4 – 20 mA Resolution 12 bit Input load resistance 100 Mega ohm (0-5VDC), 250 ohm (0 - 20 ma) Voltage: 0.10% of full scale reading, 0.20% max. Accuracy Current: 0.11% of full scale reading, 0.24% max. THERMOCOUPLE INPUT Types Supported J and K Type J -210 to +1,200 °C Ranges Supported Type K -270 to +1,372 °C Resolution 0.25 °C Typical +/- 2 °C Accuracy +/- 6 °C over the temperature range of -40 to 80 °C DIGITAL OUTPUTS Voltage range 0 - 30 VDC Output Type Open Drain Output Current Not to be less than 100ma Protection Current Limit Protection Isolation None INTEGRATED SENSORS TEMPERATURE CONDITIONS MIN TYP MAX UNITS Offset Temperature Offset Error @ 25 °C +/- 0.25 °C Slope Error +/- 0.033 °C/ °C 3 AXIS ACCELEROMETER +/-2 g, resolution of 1 mg/LSB Configurable measurement ranges +/-4 g +/-8 g Configurable output data rates 12.5Hz, 5Hz, 50Hz, 100Hz, 200Hz, 400Hz SMARTMESH IP 802.15.4E RADIO SPECIFICATIONS PARAMETER CONDITIONS MIN TYP MAX UNITS Frequency Band 2,400 2,4835 GHz Number of Channels 15 Channel Separation 5 MHz Channel Clear Frequency Where k = 11 to 25, as defined by IEEE 802.4.15 2405 + 5*(k-11) MHz Modulation IEEE 802.15.4 Direct Sequence Spread Spectrum (DSSS) Raw data rate 250 kbps 25 °C, 50% RH, +2dBi Omni-Directional Antenna, Antenna 2 m above ground Range Indoor 100 m Outdoor 300 m Receiver Sensitivity Packet Data Error Rate (PER) = 1% -93 dBm Receiver Sensitivity PER = 50% -95 dBm Output Power Delivered to a 50 Ω load 8 dBm orders@advantech-bb.com Corporate Headquarters: 707 Dayton Road, PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax 433-5104 support@advantech-bb.com European Office: Westlink Commercial Park, Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445 Wzzard™ Intelligent Edge Node With SmartMesh IP and Bluetooth LE BLUETOOTH LE RADIO SPECIFICATIONS NO. CHARACTERISTICS CONDITIONS MIN TYP MAX BT SPEC. UNIT 1 Operation Frequency Range 2402 2480 MHz 2 Channel Spacing 2 Mhz Maximum setting, measured at single ended 50ohm. 4 dBm 3 Output Power Minimum setting, measured at single ended 50ohm. -24 dBm High Gain Mode -93.0 -70 dBm 4 Sensitivity, High Gain Mode Standard Mode -92.5 -70 dBm THIONYL CHLORIDE LITHIUM BATTERIES (2 SUPPLIED WITH PRODUCT) CHARACTERISTICS CONDITIONS Temperature Range -40 to 85°C Nominal Capacity 2.4 Ah Nominal Voltage 3.6 V Diameter 14.5 mm Height 50.5 mm *Potential hazard: Do not recharge, crush, disassemble or heat above 212°F (100°C) ORDERING INFORMATION MODEL NUMBER THERMOCOUPLE INPUT WSD2CTJ Wireless Mesh 802.15.4e, 2 Thermocouple J-type Inputs, 1 Digital Output; External Antenna, Conduit Connector WSD1CTJ Wireless Mesh 802.15.4e, 2 Thermocouple J-type Inputs, 1 Digital Output; Internal Antenna, Conduit Connector WSD2CTK Wireless Mesh 802.15.4e, 2 Thermocouple K-type Inputs, 1 Digital Output; External Antenna, Conduit Connector WSD1CTK Wireless Mesh 802.15.4e, 2 Thermocouple K-type Inputs, 1 Digital Output; Internal Antenna, Conduit Connector MODEL NUMBER ACCELEROMETER WSD2XV0 Wireless Mesh 802.15.4e Integrated Accelerometer; External Antenna WSD1XV0 Wireless Mesh 802.15.4e Integrated Accelerometer; Internal Antenna MODEL NUMBER ANALOG INPUT WSD2MA2 Wireless Mesh 802.15.4e; 2 Analog Inputs, 1 Digital Output; External Antenna, M12 Connector WSD1MA2 Wireless Mesh 802.15.4e; 2 Analog Inputs, 1 Digital Output; Internal Antenna, M12 Connector WSD2CA2 Wireless Mesh 802.15.4e; 2 Analog Inputs, 1 Digital Output; External Antenna, Conduit Connector WSD1CA2 Wireless Mesh 802.15.4e; 2 Analog Inputs, 1 Digital Output; Internal Antenna, Conduit Connector Wireless Mesh 802.15.4e; 2 Analog Inputs, 1 Digital Output, 2 Thermocouple J-type Inputs; External Antenna, Conduit WSD2CJA Connector WSD2MA3 Wireless Mesh 802.15.4e; 3 Analog Inputs; External Antenna, M12 Connector WSD1MA3 Wireless Mesh 802.15.4e; 3 Analog Inputs; Internal Antenna, M12 Connector WSD2CA3 Wireless Mesh 802.15.4e; 3 Analog Inputs; External Antenna, Conduit Connector WSD1CA3 Wireless Mesh 802.15.4e; 3 Analog Inputs; Internal Antenna, Conduit Connector MODEL NUMBER DIGITAL INPUT WSD2MD2 Wireless Mesh 802.15.4e; 2 Digital Inputs, 2 Digital Outputs; External Antenna, M12 Connector WSD1MD2 Wireless Mesh 802.15.4e; 2 Digital Inputs, 2 Digital Outputs; Internal Antenna, M12 Connector WSD2CD2 Wireless Mesh 802.15.4e; 2 Digital Inputs, 2 Digital Outputs; External Antenna, Conduit Connector WSD1CD2 Wireless Mesh 802.15.4e; 2 Digital Inputs, 2 Digital Outputs; Internal Antenna, Conduit Connector ACCESSORIES PART NUMBER DESCRIPTION ACH2-DBAT-DP003 External Antenna, 2.4 GHz, 2 dBi, Dipole, RP-SMA, hinged, 3.8 dBi ACH2-AT-DP011 Magnetic Mount Antenna, 2.4 GHz, 3.8 dBi WSCAC0-6 Pigtail Cable 6 ft (1.8m) WSCAM12-6 M12 Wiring harness cable, 8 pin, 6 ft (1.8 m) ZXTMT Cable Gland/Conduit Kit orders@advantech-bb.com Corporate Headquarters: 707 Dayton Road, PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax 433-5104 support@advantech-bb.com European Office: Westlink Commercial Park, Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445 Wzzard™ Intelligent Edge Node With SmartMesh IP and Bluetooth LE APPROVALS AND CERTIFICATIONS CE EN55022 CISPR (EN55022) Class A EN 61000-6-2:2005 Generic immunity standard for (heavy) industrial environments EN 61000-6-4:2006+A1:2011 Emission standard for (heavy) industrial environments EN61000-4-2 ESD +/- 8kV air, +/- 4kV contact EN61000-4-3 RFI EN61000-4-4 EFT EN61000-4-5 Surge EN61000-4-6 CI EN60255-21-1 Vibration, 2g, 10-500Hz 0.3mm displacement EN60255-21-2 Shock, 50g, 11ms half sine wave, 18 shocks ENVIRONMENTAL IEC 60068-2-6:2007 Vibration, 2g, 10-500 Hz,1.5mm displacement IEC 60068-2-27:2008 Shock, 50g, 11ms half sine wave, 18 shocks FCC/IC FCC Part 15 Class A FCC - Part 15.247 Industry Canada - RSS210 SAFETY UL/CSA Class 1, Division 2 Group A, B, C, D REGULATORY APPROVALS ROHS and WEEE Compliant MECHANICAL DIAGRAM [ Millimeters ] Ø Inches orders@advantech-bb.com Corporate Headquarters: 707 Dayton Road, PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax 433-5104 support@advantech-bb.com European Office: Westlink Commercial Park, Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445